How do you cut veneer without chipping?

Score the cut line with a sharp razor blade. This cuts the veneer and helps reduce chipping. Run tape across the cut line in order to support the veneer and reduced chipping from tear out. Use a clean blade that’s designed specifically for cutting veneers.

How do you prevent the veneer from splintering?

To prevent your cut line from tearing:

1. Always use an appropriate blade for plywood, and be sure that it’s sharp.
2. Be sure the good face of your plywood is closer to the outside of the blade.
3. Then, add a strip of masking tape to both the top and bottom of the sheet, directly over the cut line.

Can you cut a veneer countertop?

Cutting a post-form laminate countertop to length requires a clean, straight cut. The best DIY tool for the job is a circular saw with a fine-tooth carbide blade made for laminate (the same blades are typically sold for non-ferrous metals and other types of plastics). You can also use a jigsaw with a fine-tooth blade.

What can I use as a straight edge?

If there are no markings, it is simply a straight edge. A ruler can be used for measuring and marking straight lines. A straight edge will not help you measure, but most are built more durably than rulers, making them a superior tool for marking straight lines. In most cases, rulers can function as a straight edge.

How do you cut veneer without chipping it?

This cuts the veneer and helps reduce chipping. Run tape across the cut line in order to support the veneer and reduced chipping from tear out. Use a clean blade that’s designed specifically for cutting veneers

How do you cut laminate countertops with a circular saw?

Measure the countertop carefully at least twice. Mark the line with the masking tape and set up your rip guide so your circular saw blade is aligned with the cut line. A blade depth of 1/8th inch will be sufficient, so set the saw for your cut. Slow and steady wins the race, so to speak.

How do you cut a countertop without damaging it?

A little swerving won’t hurt the end result, as the belt sander or sanding block will cure it into a straight line. Set the blade depth deeper, make another pass to cut deeper into the countertop; or, use a jigsaw for that further cut. When you’ve finished cutting through the countertop, remove the cut piece.

How do you fix a chipped veneer couch?

Some things to consider: Score the cut line with a sharp razor blade. This cuts the veneer and helps reduce chipping. Run tape across the cut line in order to support the veneer and reduced chipping from tear out.