Why does my phone keep popping the charger out?

So if you’re having issues with your iPhone constantly disconnecting from the charger, check if there are any clumps of dirt/lint. If there are, grab a toothpick, needle or SIM-card pin and gently ease them out. You can also try using a can of compressed air to blow it out too.

Why does my iPhone charger pop out?

There are several different reasons why your iPhone charger may not stay in. It’s possible the cable you’re trying to use is damaged or that your iPhone’s charging port is obstructed. You may be using a cheap knock-off cable or one that wasn’t designed to work with an iPhone.

Why does my charger feel loose?

What may be happening is lint getting accumulated in the charging port and with every insertion of cable, it gets more and more dense. After long enough time, you may notice that the cable is not going “fully” inside the charging port as it used to go when phone was new.

How to fix a loose Charger?

To fix a charger that is loose or has a short, simply squeeze the end with a pair of pliers. Do not squeeze the end too hard. The end you want to squeeze is the end that you are having the problems with.

How can I Fix my charging port that won’t charge?

If a new cable doesn’t help, you may have to replace the charging port. Take a look at the teardown and see if that is something you are comfortable with. you will have to solder a new connector to the board. The port is available at places like this. Hope this helps, good luck. Was this answer helpful?

How do I remove lint from the charger port?

My charger plug kept falling out, and it turned out the port was was partially blocked with lint! It slowly accumulated from being in my pocket all the time, and then when you plug in the charger it packs it down at the bottom. Take a stick pin and carefully scrape the lint out of the port a tiny bit at a time. Was this answer helpful?

How to keep the plug from falling out of the Jack?

The closest I can get to making it work right is by placing a tiny pony tail band around the plug. It fits perfectly into the outer jack holds it fairly steady, but still falls out easily. I may try gluing it or something.