Where is the 3/8 line on a ruler?
Table of Contents
Where is the 3/8 line on a ruler?
The very first line on the left hand side of the ruler is the 1/16 of an inch mark. Between 0 and 1 inch, there are marks that denote 1/16, 2/16 (or 1/8), 3/16, 4/16 (or 1/4), 5/16, 6/16 (or 3/8), 7/16, 8/16 (or 1/2), 9/16, 10/16 (or 5/8), 11/16, 12/16 (3/4), 13/16, 14/16 (or 7/8), 15/16, 16/16 (or 1) of an inch.
Where is 3 8th of an inch?
Fraction, Decimal, and Millimeter Equivalent Measurements
| Fraction | Decimal | Millimeters |
|---|---|---|
| 3⁄8“ | 0.375 | 9.525 |
| 7⁄16“ | 0.4375 | 11.1125 |
| 1⁄2“ | 0.5 | 12.7 |
| 9⁄16“ | 0.5625 | 14.2875 |
How do you read a ruler?
If you counted in 1/4 inches on a ruler, you’d see that the fourth line after 0 inches equals 1/4 inch, the eighth line equals 2/4 (1/2) inch, and the 12th line equals 3/4 inch. Example: Say you’re measuring a piece of cloth and the ruler ends at the fourth line after the 10-inch mark.
Where is inch in ruler?
A ruler is 12 inches long, with inch lines along the edge of the ruler (1 is at the far left and 12 is at the far right, with every number in between in numerical order). The lines at the inch numbers are the longest lines along the edge of the ruler.
What is .38 inches on a ruler?
Inch/mm equivalents table
| inch/64 | Fractional inch | Decimal inch |
|---|---|---|
| 36 | 9/16 | 0.5625 |
| 37 | 37/64 | 0.578125 |
| 38 | 19/32 | 0.59375 |
| 39 | 39/64 | 0.609375 |
What is the unit of measurement for a ruler?
The default units of measure for the rulers are picas (a pica equals 12 points). However, you can change custom ruler units and control where the major tick marks appear on a ruler.
How do you scale a ruler?
Line up the zero mark on the scale you are using with the beginning of the item you are measuring to start using a scale ruler, according to GEI International. Then, determine at what point on the scale the end of the item is, and read the number on the scale closest to that point.
How many inches are there in a ruler?
Check a ruler. One ruler is 12 inches long or 1 foot. Many rulers list the inches on one side but also list centimeters and millimeters on the other side. If your original measurement is 12 inches or below, you can use one of these rulers to measure the same distance in millimeters.
What is the full length of a ruler?
The standard ruler maintained by the U.S. National Bureau of Standards measures 6 inches on one side and 15 centimeters on the other. These measured lengths are close to each other as 1 inch equals 2.54 centimeters, or 254 millimeters. Each centimeter equals 10 millimeters.