Where are the tuning pegs of a guitar located?

head
First, let’s start with the basics of guitar tuning, The Tuning Pegs! The tuning pegs are located on the head of your guitar, and change the pitch of the guitar strings. To make the pitch go up, turn the pegs to tighten the strings. To make the pitch go down, turn the pegs to loosen the strings.

What are the two types of tuning pegs?

Sealed tuning machine heads come in two options:

• Sealed tuning nut with indexing pin: An indexing pin sits under the housing to hold the machine in place.
• Sealed tuning nut with mounted screw: The most common type, sealed tuning nuts come with a screw that holds the machine onto the guitar’s headstock.

Why are classical guitar tuning pegs different?

It’s because the strings are different. If you look at the shafts that strings are wrapped around, on classical guitar they are plastic and have much larger diameter than on acoustic. Nylon strings have lower tension than steel ones, and stretch much, much more when pulled into tension.

What is the purpose of the tuning pegs on a guitar?

They go by many names … machine heads, tuning pegs, tuning keys. But no matter what you call them, those little knobs play a huge role in how your guitar or bass performs. The reason your instrument has tuning keys in the first place is to give you the ability to easily adjust string tension.

Which direction do you tune a guitar?

To tune a guitar with six tuners in a row, turn all the tuning pegs counter clockwise to tighten the strings. Loosen the string by turning clockwise. Always tune the string from a lower pitch up to the correct note.

Can you replace tuning pegs?

Once you understand the different types of tuning pegs that go onto a guitar, you can better understand what will need to be done to install them onto a guitar without any problems. Most of the time you can just replace them with the original tuners, but sometimes, depending on the guitar, this can be a hassle.

Are all guitar tuning pegs the same size?

Most modern tuning pegs will have a standard hole size of 10 mm (13/32”) whereas vintage will often be at the 9mm (11/32”), so it’s not a huge thing to worry about when ordering tuning pegs. It’s good to just pay attention to what size you’re ordering.

Do tuning pegs make a difference?

There is a difference between the el-cheapo tuning pegs on a cheap guitar and those on a quality built guitar. Replacing them will very likely make a noticeable difference. They tend to be smoother and hold tension a bit more securely. The internal tolerances and overall quality of the parts make that difference.

Does tune up mean tighten?

Let’s begin on the sixth string, which is the thickest string. First, tune up or down until you reach the E note. Simply grab the corresponding tuning peg, and tighten or loosen it until your tuner displays the E note. If the bar/needle is off to the left, your string is flat, which means you need to tighten it.

Do you tighten guitar strings?

I like to tighten the string by hand. It’s very important to keep the string taut with your free hand; if it’s too loose, then you won’t get a nice, tight wind around the tuner, and your guitar will go out of tune easily.

Can you put any tuning pegs on a guitar?

Unless you are changing to a set of tuning pegs that have exactly the same specifications as the set that is currently on the guitar, some modifications will have to be done to the guitar to be able to install the new set of tuning pegs.