What is the measurement for fascia?

Typical widths of fascia are 6 and 8 inches. As a rule of thumb, always order 10 percent more material than calculated to ensure you have enough material.

How do you measure fascia board?

Measuring and Cutting the Fascia. Use a tape measure to find the length of your roof. Climb a ladder near the corner of your roof and tape the end of your tape measure against the rafter using duct tape. Get off of your ladder and reposition it at the other end of your roof.

How do you calculate soffit and fascia?

Multiply the total length by the width to obtain the area of soffit needed to fill the gap. For example, if the total eaves length is 110 feet, and the width is 2 feet, multiply 110 by 2. The result, 220 in this example, is the number of square feet of soffit required.

How do you measure eaves?

Be sure to verify each eave and rake overhang. Eave and rake overhangs should be measured from the exterior edge of the fascia to the exterior edge of the wall.

What is the standard size of fascia board?

Fascia Board Sizes Fascias are typically made from 1-inch material, with the width being enough to cover the rafter width. Typically rafters will range from 2×6 to 2×8, although some are larger depending on the roof construction. Therefore, the more common fascia board sizes are 1×6 or 1×8.

How do you find the linear quantity of a fascia board?

Installation Advice

1. Black.
2. White.
3. Brown.
4. Anthracite Grey.

How do you calculate soffit drops?

The calculated Soffit Drop is the measurement from top of wall vertically down to the underside of soffit sheeting. The Wall Top to Rafter Bottom measurement is from top of wall vertically down to a point level with the bottom outside edge of the rafter (not including Fascia).

How do you calculate Gable area?

Calculate the area of the gable using the formula: gable area = width x (height / 2). Using the example width of 25 feet and gable height of 10 feet, the surface area of the gable is 125 square feet: 25 x (10/2) = 125.

How is eave overhang measured?

A method to calculate the correct overhang to provide the proper shading is to multiply the distance from the sill of the glass to the soffit by a factor based on the angles of the sun. There are different factors for each latitude because the sun is at different angles at each latitude.

How do you calculate the amount of concrete you need?

How to calculate concrete: Determine how thick you want the concrete Measure the length and width that you’d like to cover Multiply the length by the width to determine square footage Convert the thickness from inches to feet Multiply the thickness in feet by the square footage to determine cubic feet

How do you calculate the volume of a concrete footer?

Calculate concrete volume of a footer Using measurements in feet: Volume in Cubic Feet (ft 3) = Width x Length x Depth Volume in Cubic Yards (yd 3) = Volume in Cubic Feet (ft 3) / 27

How do you calculate the square footage of a concrete patio?

Multiply the thickness in feet by the square footage to determine cubic feet Convert cubic feet to cubic yards by multiplying by.037 Here’s what the math looks like for a 10’ by 10’ concrete patio: 10 x 10 = 100 square feet

How do you calculate fascia board size?

Multiply the 1-1/2 inch width of the fascia board by the slope of the roof (e.g. 4/12). 1.5” times 4 divided by 12 = 0.5 or ½ inch. For a 2×6 fascia board at a 4/12 slope, the trim size would be 1-1/2 inch x 5 inches for an overhang without a soffit.