What is a good audio level for recording?

You should record vocals at an average of -18dB for 24-bit resolution. The loudest parts of the recording should peak at -10dB and be lowest at -24dB. This is to keep an even balance on the level of the vocals without distortion.

How many dB should Mic be?

16-19 dB-A is good enough for most purposes. You may hear some noise when you record relatively quiet instruments, but it’s usually unobtrusive. 20-23 dB-A is a pretty high self-noise figure for a studio microphone. This is an area where every decibel counts, because we’ve reached a noise level that’s clearly audible.

What is a good DB for streaming?

There are two tools with which you can remedy these issues and ensure that when mastering, a loudness of -14 LUFS will be sufficient for all streaming services.

Can you use XLR for line-level?

Connectors and Signal Levels. The standard XLR 3-pin output connector on most mics can carry mic-level signals or line-level signals. The 1/4″ connectors are used for low-level guitar outputs as well as speaker inputs from a power amp, which are drastically different levels.

Is XLR always mic level?

Also note that XLR inputs on a mixing desk are “mic level” inputs, however the XLR outputs (generally 2 of them) are always set to line level, ready for connection to a line input on a powered speaker, amplifier or processing device. XLR outputs are generally always balanced, whether mic or line level.

What are audio levels for video recording?

One aspect of recording quality sound is getting the ideal audio levels for video right. To do that, you need to understand a little about audio levels. In simple terms, the audio level is the loudness of the audio. It may also be referred to as the gain, although the gain is normally the input level from the microphone.

What should the input level be on my audio interface?

Make sure to set the input level on your audio interface at this same point (-12db to -6). It is important to keep this level at the source and work your way back to the DAW input. Your signal should be set properly at the input of every device in your audio chain.

How to properly set audio levels?

If this is the case with your audio interface there is a simple way to properly set your levels. Push your input source signal until it shows clipping, then back off the input about 6 db.

How to be certain your recording is loud enough?

Setting Recording Input Level. Or, How to Be Certain Your Recording Is Loud Enough. An important aspect of the technical side of getting a good recording is to properly set the volume level of the recording input. This is the level at which your recording device is receiving your voice while you read.