What do I do if my Epson printer is not printing properly?

Try removing your cartridges from your printer, and then shutting your printer down. Turn it on after a few hours and wait for your printer to recognize that there aren’t any cartridges installed in the printer. Install all of the cartridges back into the printer and try printing.

How do you reset your Epson printer?

To Factory Reset an Epson printer:

1. Turn off the printer.
2. Press and hold the reset button on the back of the printer (normally located to the right of the ethernet port).
3. Turn on the printer while holding the reset button.
4. Wait until a message prints indicating that the printer is resetting.

How do I run a diagnostic on my Epson printer?

Hold down the paper button and press the power button to turn on the printer. Then, release only the power button. When the printer starts the operation check, release the paper button.

How do you fix a print issue?

Try following these steps to get your printer back online.

1. Check to make sure the printer is turned on and connected to the same Wi-Fi network as your device.
2. Run a printer power cycle.
3. Set your printer as the default printer.
4. Clear the print queue.
5. Reset the service that manages the printing queue.

How do I clean the rollers on my Epson printer?

Cleaning the Paper Rollers

1. Turn off the product.
2. Unplug the power cable.
3. Disconnect any connected cables.
4. Remove both paper cassettes.
5. Place the product on its right side.
6. Use a soft, moist cloth to clean the cassette rollers shown here.
7. Return the printer to its normal position.

How do I reset my Epson wireless printer?

Reset the Printer’s Network Settings for the Epson Artisan 800

1. If necessary, press the Home button on the control panel to return to the Home menu, then select Setup.
2. Press , then press Restore Default Settings.
3. Press Reset Network Settings.
4. Select Yes as necessary to reset the printer’s network settings.

Why is the orange light blinking on my Epson printer?

When the printer shows orange light blinking, it mostly means some issues with the printer cartridge, toner, or simply corrupted configuration settings as reported by the user in the Microsoft Community.

Why is the green light flashing on my Epson printer?

The product is busy. Wait for the power light to stop flashing before turning off the product. If you just replaced an ink cartridge and the power light is still flashing after 3 minutes, the cartridge may be installed incorrectly. You can continue printing, or check which cartridge is low and replace it.