How do I stop DStv scanning?

Release the P+ button immediately the “CODE” message appears and press -++- instantly. After that, the DStv not scanning problem will be gone. It will start scanning properly and channels restored.

Why does my decoder keeps rebooting?

The main cause of the DStv Explora 2A keeps rebooting problem is a damaged DStv software. Often, Multichoice releases new decoder systems, and you can download them when you connect your decoder to the internet.

What causes DStv not to scan?

➢ Dstv not scanning : The most basic reason as to why your dstv is not scanning is because the dstv dish signal is so poor at the time. Probably due to bad weather or a poor dish installation for new customers or a the dstv dish alignment with the dstv satelite has changed.

What does orange light on DStv decoder mean?

If your subscription is running out, you need to update, or there is an upcoming show saved, you will receive the orange light on DStv decoder. It is very convenient and will ensure you never miss out on any important information from Multichoice.

How do I fix my DStv signal strength?

How To Fix Signal Strength On DStv?

1. Check F-type connectors. Check for incorrectly connected F-type connectors on the LNB and at the back of the decoder.
2. Correct the LNB alignment.
3. Adjust satellite dish alignment.
4. Replace a faulty LNB.
5. Move your satellite dish.
6. Cut down or prune trees that may obstruct the signal.

How do I fix my DStv Explora reboot?

1. Hold the POWER button on your decoder down, till the front panel shows a blank screen 2. Then hold down the P+ button, until CODE appears on the front panel 3.
2. If successful, please remember that it will take at least 48-72 hours for your BoxOffice and Catch Up to populate again.
3. Enjoy your viewing.

How do you rescan a decoder?

Press the DStv button on the remote. Scroll to Settings. Then to System Settings. Select Reset Decoder Setting.

How do I test my DStv signal?

Once you encounter a poor signal error, you can press the HELP button on your remote and click on General Information. Then, click on Select Tuner Status Signal Quality & Strength. Here you will be able to view the strength of the signal. All of these values should be either 50\% or above.

How do I clear the orange light on my DStv decoder?

All you have to to is go to mail messges on your decoder to read your unread messages and the falshing Amber will stop.

Why won’t my DStv decoder scan channels?

Also, if the cable is broken or the LNB is faulty, you will have problems getting channels. Solve DStv decoder installation wizard error and channels scanning problems by factory resetting your decoder using the P+ and P- buttons.

Why does the decoder fail to scan?

→ Scanning for too long: In this situation, the decoder takes too long to scan and after scanning may experience pixilation (picture cracks) or signal disconnection on some stations. This problem is caused by low signal strength to the decoder.

Why does my TV keep disconnecting from the signal?

The problem is caused by a change in the dish (signal) position or a bad LNB or in rare cases a faulty decoder. → Scanning for too long: In this situation, the decoder takes too long to scan and after scanning may experience pixilation (picture cracks) or signal disconnection on some stations.

Why does my decoder keep rebooting when switched on?

Most of which have been about their dstv decoders constantly rebooting when switched on. Most people say the reboot happens in seconds, just as the decoder initiates the channel scan. This particular problem occurs due to many reasons, but the most common cause is a failed software upgrade.