Interesting

How do I change a water pump?

How do I change a water pump?

Loosen the bolts and remove the old water pump. Remove the old seal/gasket or old sealant remains and make sure the mounting surface is clean. Before installing the new water pump, inspect the other cooling system service parts: coolant hoses, thermostat and pressure cap(s). Install the new water pump.

How much horsepower do a 2006 SS Impala have?

Used 2006 Chevrolet Impala SS Specs & Features

Engine
Cylinders V8
Horsepower 303 hp @ 5,600 rpm
Torque 323 lb-ft @ 4,400 rpm
Valves 16

What kind of motor is in a 2006 Impala SS?

V-8
SS 4dr Sedan 2006 Chevrolet Impala Specs

Performance
Base engine size 5.3 liters
Base engine type V-8
Horsepower 303 hp
Horsepower rpm 5,600
READ ALSO:   What is network analysis and its importance?

How many miles can a 2006 Chevy Impala go on a full tank?

Compare Side-by-Side

2006 Chevrolet Impala
EPA Fuel Economy Regular Gasoline
22 MPG 18 28 combined city/highway city highway
4.5 gal/100mi
374 miles Total Range

Can I change my water pump myself?

The location of the water pump in relation to the engine can vary by application. Whether you can replace it yourself depends on how much experience you have. However, a person who easily figures out how to do things can usually replace a water pump that is on the front of the engine, without any mechanical experience.

How do you remove a water pump pulley without a puller?

Can You Remove the Power Steering Pump Pulley Without a Puller?

  1. With the pump taken off the vehicle, place it in a vice and use a piece of metal pipe and a hammer to tap the wedge between the pulley and the pump.
  2. Heat the center of the pulley with the blowtorch and pull it off.
READ ALSO:   Where is the Elder Wand buried?

Is the 2006 Impala SS reliable?

2006 Impala It us reliable, has plenty of room and rides good on trips.

How fast is a 2006 Impala SS?

154 mph
We certainly can’t argue with this kind of performance from a family sedan that starts at $26,990 – there’s that 0-to-60 time of 5.6 seconds, the quarter-mile turns in 14.2 seconds at 101 mph, and the ungoverned top speed is 154 mph.

What is a 2006 Chevy Impala worth?

2006 Chevrolet Impala trade-in prices range from $965 – $7,303. Get a more accurate value for your car with the Edmunds appraisal tool.

How long does a 2006 Chevy Impala last?

Your chevy impala can last up to 160,000 miles with regular maintenance checks before its major components like the transmission may fail.

Is it difficult to change a water pump on a car?

While removing the pump is not difficult, you must have experience removing and replacing timing belts and their various components. It takes just as much work to get down to the timing belt as it does the water pump, therefore you should plan on replacing the belt at the same time.

READ ALSO:   Where are breast cysts usually located?

What tools are needed to change a water pump?

TO CHANGE YOUR WATER PUMP YOU WILL NEED:

  • Sockets and wrenches.
  • Screwdriver.
  • Pliers.
  • Drain pan.
  • Rags.
  • Gasket sealer.
  • Antifreeze.