What are the components of a power system in the rig?

Main components comprise the drilling rig are:

• Power system.
• Hoisting system.
• Rotary system.
• Circulating system.
• Well control &monitoring system.

What are the major systems in an oil rig?

In particular, all modern hydrocarbon rotary rigs contain five main systems….These systems are:

• the Power System.
• the Hoisting System.
• the Rotary System.
• the Circulation System.
• the Well Control System (Blowout Prevention System)

What are the main components of the rotary system?

The basic rotary drilling system consists of four groups of components – the prime movers, hoisting equipment, rotating equipment and circulating equipment – that all combine to make rotary drilling possible.

What is well control system?

The Well Control System or the Blowout Prevention System on a drilling rig is the system that prevents the uncontrolled, catastrophic release of high-pressure fluids (oil, gas, or salt water) from subsurface formations. These uncontrolled releases of formation fluids are referred to as Blowouts.

What is rig system?

• Circulating system. • Rotary system. • Well control system. The rig is basically comprised of a derrick, the drawworks with its drilling line, crown block and traveling block, and a drilling fluid circulation system including the standpipe, rotary hose, drilling fluid pits and pumps.

How does an oil rig get power?

The most common way to supply enough power to the rig is through the use of diesel-powered generators. As such, the generators that are produced to be used on oil rigs must be built with materials and coatings that can withstand the temperature-extremes, water, saline and wind that are present offshore.

How much power does an oil rig use?

Offshore oil and gas platforms use 16 terawatt-hours a year to power their operations. This is an opportunity for wind and solar.

How does the rotary drilling system work?

Rotary technology uses a sharp, rotating drill bit and downward pressure to cut, or crush, through the subsurface. Impact energy is supplied to the drill bit from either an above ground or down hole impact hammer. This impact force aids in the drilling.

What is shut in drill pipe pressure?

SIDPP
Shut-in drill pipe pressure (SIDPP), which is recorded when a well is shut in on a kick, is a measure of the difference between the pressure at the bottom of the hole and the hydrostatic pressure (HSP) in the drillpipe.

What is the SCR system in drilling rig.?

For the past three decades, drilling equipment has been DC driven by Silicone Controlled Rectifier (SCR) systems, which converts AC to DC and enables motors to run at variable speeds. However, SCR voltage from DC systems has limited output.

How does a drilling rig mud pump work?

A drilling rig mud pump is used to circulate drilling fluid or drilling mud into the bore hole to help cool, lubricate and clean the drill head as it bores into the ground. The drilling mud is also used to suspend and carry out drill cuttings from the drill head as it is brought in and out of the hole.

What are the components of a drilling rig?

Major components of the rig include the mud tanks, the mud pumps, the derrick or mast, the drawworks, the rotary table or topdrive, the drillstring, the power generation equipment and auxiliary equipment. Offshore, the rig includes the same components as onshore, but not those of the vessel or drilling platform itself.

What is jackup drilling rig?

Jackup Drilling Rig, also known as a self-elevating unit or jackup rig, is a mobile unit which contains a buoyant hull that is fitted with various movable legs adept in raising the hull over the sea surface.

https://www.youtube.com/watch?v=EDbKmHtN-Fg