Will a stud finder work on a popcorn ceiling?

Since popcorn ceilings are textured, a stud finder cannot be level on them. You simply need to place something flat on the ceiling in between the stud finder and texture. To create a flat surface for the stud finder, simply place a thin piece of cardboard on the popcorn ceiling.

How do I find the joists in my ceiling without a stud finder?

Try a Small Nail While your there, measure the distance between joists to see if they are 16 or 24-inches apart. When you go back downstairs, you will see the nail, know which way the joists run and how far apart they are, so you can use your measuring tape to find the joist you need.

How do you find rafters through a popcorn ceiling?

How to Use a Stud Finder on a Popcorn Ceiling

1. Access the ceiling by standing on a ladder.
2. Press a thin piece of cardboard against the ceiling area where you would like to find the joist.
3. Press the stud finder onto the left side of the cardboard.
4. Activate the device’s deep scanning option.

How far apart are studs in ceiling?

Ceiling joists are usually installed either 16 or 24 inches on center, which means roughly 16 or 24 inches apart.

How does a stud finder work?

Low-end stud finders use magnets or electricity to detect a stud. These stud finders detect the fasteners in the drywall and alert the user once the magnet is attracted to the metal fastener. Stud finders that use electricity detect changes in the dielectric constant of the wall to find studs.

How far apart are studs in the ceiling?

How do you find studs on a popcorn wall?

If you’re not finding studs behind a textured surface, the first thing to do is get a thin piece of cardboard or poster board. Hold it against the wall, turn the tool on, and scan with the cardboard in place. If that doesn’t work, try the tools Deep Scan Mode if your stud sensor has it.

How do you find ceiling joists on a popcorn ceiling?

How far apart are studs?

16 inches
The general spacing for wall studs is 16 inches on center, but they can be 24 inches. At my home, the exterior wall studs are spaced at 24-inch centers, but the interior walls are 16 inches on center.

How do you find the studs in a popcorn ceiling?

Place a sewing pin into the popcorn ceiling along this indicated trajectory for the joist’s edge; do not press it through the cardboard. This pin will help you locate the stud after removing the cardboard.

How do you find the joist edge on a popcorn ceiling?

Stop moving the stud finder when its LED (light emitting diode) indicates that it has found the joist’s edge. Place a sewing pin into the popcorn ceiling along this indicated trajectory for the joist’s edge; do not press it through the cardboard. This pin will help you locate the stud after removing the cardboard.

How do you find ceiling joists between studs?

Press a thin piece of cardboard against the ceiling area where you would like to find the joist. Since studs are approximately 16 to 24 inches apart, the cardboard should be about 2-by-2 feet in size for the best coverage.

How do I use the cardboard stud finder?

Hold the cardboard in place with one hand. Press the stud finder onto the left side of the cardboard. Activate the device by pressing the “On” button. Allow it to boot up.