Why do my songs sound flat?

The ‘dull soft’ sound is due to a number of factors and you have mentioned most of them (eq, compression, stereo spread, saturation and volume). As each sound in your mix is different, there are no hard rules to getting this sounding ‘bigger’. Different parts of the mix require different processing.

How do I make my mix sounds clearer?

10 Mixing tips and tricks to create a clear mix

1. Bass your worse enemy.
2. Use Reverb as delay.
3. Side chain compress the import parts that need it.
4. Parallel compress your drums.
5. avoid the stereo imager in the mix use mid side routing instead.
6. phase / delay to create space.
7. notch filter to create space.

Why do my songs sound muddy?

The most common part of a mix that gets muddy is the 200-500Hz area. Fixing it is as easy as carving out a bit of space in these frequencies. Go back to your EQ insert on the tracks that are still sounding a bit muffled. Select the frequency range that you’d like to target and tweak it until it’s sounding better.

Why does my mix sound thin?

In fact, thin mixes usually come from a poor arrangement. But sometimes they can come from a poor use of EQ, too. When you prevent and address thinness in your track, you can produce a mix that’s more powerful and impactful. You never want an important chorus to sound thin – the music will lose it’s impact.

How do I stop clipping in Logic Pro?

To avoid clipping, you need to bring down the Volume fader by the same value that is shown in the peak level display. For more information, see Set channel strip volume in Logic Pro.

How do you stop a mixing sound muddy?

5 Tips To Avoid Ruining Your Mix With Muddy Sound

1. Get it right at the source.
2. Manage your low end in the stereo field.
3. Don’t be afraid to filter.
4. Be extra-careful EQing your low mids.
5. Keep good headroom.

Why does my mix sound bad?

1. It sounds too narrow. One of the most common problems with mixes occurs when too much is happening in any one part of the musical plane (or to look at it another way, not enough). Try to think of music in three dimensions, and first, check the width.

What can you do with Logic Pro X?

Support for pristine 24-bit/192kHz audio. Logic Pro X makes it all easy to do — and undo. You can create projects with up to 1000 stereo or surround audio tracks and up to 1000 software instrument tracks, and run hundreds of plug-ins. It’s all you need to complete any project.

How to compress vocals in Logic Pro?

Use the loop control in Logic to select a section of vocals, and open up the compressor plugin. Start with a modest ratio of 2:1-4:1 (4:1 is generally seen as the middle ground in compression ratios). Roll back the threshold control until the compressor starts engaging when the loud vocals kick in.

How do you use Autotune in Logic Pro X?

In a time before Autotune *gasp*, USB microphones and digital audio workstations like Logic, mixing a track was an incredibly complex and laborious activity. In minutes, you can use Autotune in Logic Pro X to clean up a vocal track, switch to the Scissors tool to make some quick cuts, and apply automation in an instant.

How do I use quick sampler in Logic Pro?

Drag and drop an audio file from the Finder, Voice Memos, or anywhere within Logic Pro. Or record audio directly into Quick Sampler using a turntable, microphone, musical instrument, or even channel strips playing in Logic Pro. In a few steps, you can transform an individual sample into a fully playable instrument.